User's Manual

Using Your BreezeMAX USB250 Settings the WiMAX Connection Manager (WCM)
BreezeMAX USB 250 10 User Manual
2 In the Basic tab select or deselect the following and click OK:
» Automatically Start CM when Device is Plugged: If it is enabled, WiMAX
Connection Manager starts automatically when the USB250 is plugged into
the PC. (Default: Enabled)
» Automatically Connects When CM Starts: If it is enabled, WiMAX
Connection Manager tries to connect to WiMAX network automatically
when it starts. (Default: Enabled)
» Language (if enabled for display): select the language (default: English).
3 To initiate SW Upgrade procedure, click the Update button . Refer to
“Software Upgrade” on page 17.
4 In the Authentication tab (see Figure 9) specify the following and click OK:
» Method: Select one of the following WiMAX security method:
◊ None - authentication is disabled
◊ EAP-TTLS/MS-CHAPv2 (default) - Extensible Authentication
Protocol-Tunneled Transport Layer Security, supporting the Microsoft
version of the Challenge-handshake authentication protocol, version 2.
◊ EAP-TLS - Extensible Authentication Protocol Transport Layer Security
(not supported in current release).
» User Identity: Enter the user name supplied by the service provider
(Default: [e-mail]).
» User Password: Enter the user password supplied by the service provider.
(Default: quickynikynyoky).
» Realm: Enter the WiMAX domain for EAP used by Supplicant (Default:
WiMAX.com).