WIXS-181 Quick Installation Guide
This Quick Installation Guide is intended for experienced installers. Package Content Check that the package contains: ODU(Outdoor unit) PoE(Power Over Ethernet) and Power plug RJ45 CABLE CONNECTOR ASS'Y Pole mounting kit Additional Equipment and Tools required for Installation PoE-to-outdoor Category 5E Ethernet cable with two shielded RJ-45 connectors and an RJ-45 connectors crimping tool.
ODU Installation Mounting the ODU Mount the ODU unit using the supplied kit: Preparing the PoE-ODU Cable Use a crimp tool for RJ-45 connectors to prepare the wires. Insert them into the appropriate pins and use the tool to crimp the connector. Make sure to do the following: Remove as small a length as possible of the external jacket. Verify that the external jacket is well inside the sealing cover when connected to the unit, to ensure good sealing.
PoE Installation 1. 2. 3. 4. The unit can be placed on a desktop or a shelf. Alternatively, it may be wall-mounted. Connect the PoE-ODU cable to the DATA & POWER OUT port. Connect the PoE to the AC mains. Connect ETHERNET port to a PC/Hub/Switch. Basic Configuration 1. 2. 3. 4. 5. 6. Use the Web Configuration Server to configure the basic parameters. Connect a PC/Notebook to the POE.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
