Quick Installation Guide
Table Of Contents
- Introduction
- Professional Installation Instructions
- Instructions d'installation professionnelle
- Overview
- Package Content
- Additional Installation Requirements
- Installing the ODU
- Selecting a Location
- Mounting the ODU
- Installing The IDU
- Connecting the Cables
- Outdoor Connections
- Checking for Proper Operation
- Commissioning
- Federal Communication Commission Interference Statement
- FCC Radiation Exposure Statement
- Europe - EU Declaration of Conformity
- Industry Canada statement
PRO 6000 CPE Quick Installation Guide
P/N 216000 -8- May 2012
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 60cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Europe - EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test methods have been
applied in order to prove presumption of conformity with the essential requirements of the R&TTE Directive 1999/5/EC:
• EN 60950-1:2006 + A11:2009 + A1:2010 + A12: 2011
• EN 302 326-2 V1.2.2: 2007
• EN 302 326-3 V1.3.1 : 2008
• EN50385 : 2002
• EN 301 489-1 V1.8.1 (2008-04)
• EN 301 489-4 V1.4.1: 2009
Industry Canada statement
This device complies with RSS-192 & RSS-197 of the Industry Canada Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-192 & CNR-197 d'Industrie Canada applicable aux appareils radio exempts de
licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage
préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un
fonctionnement indésirable.
NOTE!
Radiation Exposure Statement:
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 60 cm between the radiator & your body.
Français Pour l'utilisation de dispositifs mobiles
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement
non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 60 cm de distance entre la
source de rayonnement et votre corps.
CAUTION
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment