Quick Installation Guide
Table Of Contents
- Introduction
- Professional Installation Instructions
- Instructions d'installation professionnelle
- Overview
- Package Content
- Additional Installation Requirements
- Installing the ODU
- Selecting a Location
- Mounting the ODU
- Installing The IDU
- Connecting the Cables
- Outdoor Connections
- Checking for Proper Operation
- Commissioning
- Federal Communication Commission Interference Statement
- FCC Radiation Exposure Statement
- Europe - EU Declaration of Conformity
- Industry Canada statement
PRO 6000 CPE Quick Installation Guide
P/N 216000 -7- May 2012
Commissioning
1 The PC receives an IP by DHCP, as DHCP server is enabled by default. Alternatively you can manually set the PC's IP
settings to 192.168.254.250, then follow the instructions below to access the web interface and start the Setup Wizard.
2 From a connected PC, use a web browser to access the CPE’s web interface. The web interface allows you to configure
WiMAX settings.
3 Open your web browser and type the IP address 192.168.254.251
4 Type the default username/password: admin/admin and click LOGIN .
5 Configure the basic parameters required for connectivity with the BTS. The following table includes the basic parameters and
their default values.
Basic Parameters
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with RSS-192 and 197 of the Industry Canada Rules. This equipment also
complies with the limits for a class B digital device, pursuant to ETSI EN 301 489-1 and Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
3 x WiMAX link signal strength LEDs Green
• Lights at start up.
• Off - upon BIT completion
Signal strength display:
• LED1 blinks when 12>SNR≥8dB
• LED1 lights when SNR≥12dB
• LED2 blinks when 18>SNR≥15dB
• LED 2 lights when SNR≥18dB
• LED3 (right side) blinks when 25>SNR≥20dB
• LED3 (right side) lights when SNR>=25dB
Figure 9: ODU LEDs
Table 1: Basic Parameters
Item Default Value Comment
User Name (WiMAX) WAN mac address and WiMax.com
realm, e.g:
0026824EE12C@WiMax.com
Should be supplied by system
administrator. Configured in the
Advanced> Authentication window
WiMAX Password quickynikynyoky
Domain
(also Eng > WiMAX Config > Realm)
Frequency Full Scan Should be supplied by system
administrator.
Telephony - SIP Server, phone number,
authentication, enable the phone
Disabled Optional
VoIP is disabled by default and should
be enabled by the operator
Description Color Functionality
Fault + Eth indication (red)
3 x WiMAX link signal
strength (green)
WiMAX W/L link
availability (green)