Quick Installation Guide

PRO 6000 CPE Quick Installation Guide
P/N 216000 -3- May 2012
Mounting the ODU
Mount the ODU unit on a 1"-4" pole using the supplied kit (Figure 2), or the optional Tilt accessory.
Using the Clamp
1 Thread the M10*100mm bolt through a spring washer, flat washer and the bracket holes.
2 With the connector facing downward, attach the ODU to a 1" -4" pole.
3 Attach the bracket to the other side of the pole.
4 Thread the M10*100 mm bolts through both holes on either side. Tighten the nuts.
Using the Tilt Accessory
1 Attach the Tilt accessory to the ODU using the two pairs of flat washers, spring washers and nuts supplied in the Tilt kit.
2 Mount the Tilt accessory on a 1" to 4" pole using two 9/16" metal bands.
3 Slightly release the Tilt Control Screw, tilt the ODU downward/upward as required, and re-tighten the screw.
Figure 2: Mounting the ODU on the Pole
Figure 3: ODU Pole Installation Using the Tilt Accessory, Vertical Polarization
Weather Proof Sealing
Glands
Protect the RJ-45 Ethernet Port
Pole-Mount Bracket
Attaches to a 1~4 inch
diameter pole
M10*100 Bolt, nuts and
spring washers
Tilt Control Screw
Tilt Accessory