User's Manual

............................................................................................................................................................................................................................................................
Route SettingAdvanced Setup
9-2
3EQ-10422-AAAA-TCZZA
Edition 01 February 2011
............................................................................................................................................................................................................................................................
Figure 9-1 Route Setting window
Table 9-1 describes the fields of the Route Setting window.
Table 9-1 Field descriptions
Field Description
Static Route Static routing enables you to configure a pre-determined path that
network traffics need to travel to reach other network or host.
IP Destination Enter the IP address of the destination network.
IP Netmask Select the subnet mask of the destination network.
Gateway Enter the IP address of the gateway for the destination network.
Metric In order to determine the best route, a value is used to specify the
cost of the route (the metric value). Enter the metric value in the
metric field. IP routing uses hop count as measurement of the
metric.
Interface Select LAN or WAN interface. The packets sent to the addresses of
the destination IP address are sent through this interface. However,
for the WAN interface it will depends on the WAN configuration.