User's Manual

............................................................................................................................................................................................................................................................
WAN PTM ConnectionsNetwork
6-6
3EQ-10422-AAAA-TCZZA
Edition 01 February 2011
............................................................................................................................................................................................................................................................
Port based binding
Port based mode enables you to bind ports to your WAN connection. You can bind LAN
ports 1 to 4 and WLAN SSID 1 to 4 in the WAN mode you selected. The default WLAN
SSID number is 1 and you can configure 2 to 4 in the WiFi Setting.
You can select the Port Based radio button for each WAN mode and then click Add to
proceed to the next configuration window.
In Port based mode, you can add up to four connections in routed mode.
Note: If you do not set a VLAN ID in the connections, you can only have one
connection in Static IP or DHCP mode and three connections maximum in PPPoE.
Note: If you already have a connection with Port based binding, you can not select
MAC based binding for any other connections.
The following WAN modes support port-based binding:
Static IP
DHCP
PPPoE
Bridge
Static IP
If you select Static IP as the mode in the WAN PTM Connections, the Static IP settings
window with Port based binding opens; see Figure 6-4.
CMWP (CPE WAN Management
Protocol)
Provide remote control service. It will allow remote
ACS server to manage this gateway.
IGMP (Internet Group Management
Protocol) Proxy
Provide service to be used for video streaming and
gaming.
Default Route Set the connection as the gateway of last resort,
every unknown packet will be forwarded via default
route.
Add Click to add the new connection and brings you to
next step.
Delete All Delete all connections below in the table.
Edit Modify the connection setting.
Delete Delete the connection.
Field Description