User's Manual

To install the CellPipe 7130 RGHardware installation
............................................................................................................................................................................................................................................................
3EQ-10422-AAAA-TCZZA
Edition 01 February 2011
2-3
............................................................................................................................................................................................................................................................
Figure 2-1 Cable connections of 6Ve.A4111 & 6Vz.A4111
Procedure
1. Connect the power adapter’s cord into the power socket on the back of CellPipe 7130
RG and plug the power adapter into a power source.
2. Connect one end of the RJ-11 cable into the VDSL port on the CellPipe 7130 RG and
the other end to your telephone/DSL service connection.
3. Connect one end of the RJ-45 Ethernet cable to one of the Ethernet LAN port (1 to 4)
on the CellPipe 7130 RG and the other end to the ethernet port on your device (such as
PC, or a hub if your are setting up Intranet).
4. Turn the power switch on.
........................................................................................................................................................
E ND OF STEPS
You must also configure the Internet properties on your computer; Please refer to the
TCP/IP Appendix or Quick Installation Guide for detailed instructions.
After setting up and configuring the CellPipe 7130 RG and your PC(s), you can access the
web configuration tool.