User's Manual
Table Of Contents
- About this document
- Contents
- 1 Product overview
- 2 Hardware installation
- 3 TCP/IP configuration
- 4 Accessing the CellPipe 7130 RG web configuration tool
- 5 Status
- 6 Network
- 7 WiFi Setup
- 8 Firewall Setup
- 9 Advanced Setup
- 10 QoS PTM Setup
- 11 Utilities
- 12 Telephony
- 13 USB Service
- 14 FCC and IC Statement
- A Troubleshooting
- B Product conformance
- Glossary
............................................................................................................................................................................................................................................................
OverviewTroubleshooting
A-2
3EQ-10422-AAAA-TCZZA
Edition 01 February 2011
............................................................................................................................................................................................................................................................
Message LED is
flashing.
A firmware upgrade is in
progress.
• Verify that a firmware
upgrade is in progress.
• Wait until the firmware
upgrade is finished.
Intenet LED is off. Your CellPipe 7130 RG is
unable to connect to the Internet
or CellPipe 7130 RG is not
power on.
• Verify that your CellPipe
7130 RG has configured
WAN connections properly.
• Verify that the power is
switched on.
Symptom Possible cause Solution