User's Manual
Table Of Contents
- About this document
- Contents
- 1 Product overview
- 2 Hardware installation
- 3 TCP/IP configuration
- 4 Accessing the CellPipe 7130 RG web configuration tool
- 5 Status
- 6 Network
- 7 WiFi Setup
- 8 Firewall Setup
- 9 Advanced Setup
- 10 QoS PTM Setup
- 11 Utilities
- 12 Telephony
- 13 USB Service
- 14 FCC and IC Statement
- A Troubleshooting
- B Product conformance
- Glossary
............................................................................................................................................................................................................................................................
Service SettingsTelephony
12-6
3EQ-10422-AAAA-TCZZA
Edition 01 February 2011
............................................................................................................................................................................................................................................................
Warm Line destination Enter a phone number for as warm line’s destination. When warm
line is activated, putting the phone on-hook will automatically
makes a call to the warm line’s destination after the warm line
timer has expired.
Active Code The activation code for your “Hot Line/Warm Line” service.
Deactivate Code The deactivation code for your “Hot Line/Warm Line” service.
Interrogate Code The interrogate code for your “Hot Line/Warm Line” service..
Session Timer Check Active to enable session timer. When session timer is
enabled, the RG will periodically send a refresh message to refresh
the session.
Default Session Expire Enter the number of seconds to refresh the session.Default value is
1800, and the minimum value is 90.
Minimal Session Expire Enter the number of seconds as the minimal session expire. This
value will be the minimum refresh timer you can accept from the
caller.
Refresh Method Select INVITE or UPDATE from the drop-down menu. This will
be the type of message to send for refreshing session.
Refresh Preference Select a refresher preference from the drop-down menu. Select
NONE to let RG decide. Select UAC to let caller refresh the
session. Select UAS to let caller refresh the session.
Do Not Disturb
Active Code The activation code for your “Don’t Disturb” service.
Deactivate Code The deactivation code for your “Don’t Disturb” service.
Interrogate Code The interrogate code for your “Don’t Disturb” service..
Anonymous Call
Rejection
Active Code The activation code for your “Anonymous Call Rejection” service.
Deactivate Code The deactivation code for your “Anonymous Call Rejection”
service.
Interrogate Code The interrogate code for your “Anonymous Call Rejection”
service..
Call Forwarding
Enable Splash Ring Check this item to remind you have a call still holding on line.
Field Description