User Manual

%

,VVXH 0D\

% &RQILJXULQJWKH7&3,3
SURWRFROVRQWKH3&
2YHUYLHZ
3XUSRVH
To connect the CPE to a PC through its Ethernet port, the PC must have an Ethernet
network adapter card installed, and be configured for the TCP/IP protocol. Many service
providers configure TCP/IP for client PC automatically using a networking technology
known as Dynamic Host Configuration Protocol (DHCP). Other service providers may
specify an IP configuration (known as a static IP address), which must be entered
manually.
Carry out the following steps to check that the computer’s Ethernet port is correctly
configured for DHCP.
:LQGRZV17
1. Click “Start/Settings/Control Panel.”
2. Click the “Network” icon.
3. For Windows NT, click the “Protocols” tab.
4. Select “TCP/IP” from the list of network protocols; this may include details of
adapters installed in your computer.
5. Click “Properties.”
6. Check the option “Obtain an IP Address.”
7. Click “OK” to close the TCP/IP Properties window.
8. Restart your computer.
:LQGRZV
1. Click “Start/Settings/Network and Dial-up Connections.”
2. Right-click “Local Area Connections.”
3. Select “TCP/IP” from the list of network protocols.
4. Click on “Properties.”
5. Select the option “Obtain an IP Address.”
6. Click “OK” to close the TCP/IP Properties window.
7. Restart your computer.