User Manual
2YHUYLHZ7URXEOHVKRRWLQJ
$
,VVXH 0D\
DIAG LED is
flashing
At the moment a CPE
firmware upgrade is
executed.
•
Wait until the firmware upgrade is passed and
the DIAG LED is “On” (wireless enabled).
INTERNET
LED is “Off”
You cannot connect to
the Internet. The PC
may not be configured
as required or the
network adapter driver
may not fit.
•
Check that your PC is properly configured for
TCP/IP. (See Configuring the TCP/IP
protocols on the PC).
•
Make sure the correct network adapter driver
is installed for your operating system. If
necessary, try reinstalling the driver.
•
Check that the speed of the network adapter or
duplex mode has not been configured
manually. We recommend to set the adapter to
auto-negotiation when installing the network
driver.
•
Did you establish your network connection
before starting your browser?
•
Verify your username and password entry in
the network connection tab.
6\PSWRP 3RVVLEOHFDXVH 6ROXWLRQ