User Manual

FCC

Legal notices

Enterprise Services, Inc. Other brands and product names are trademarks

or registered trademarks of their respective holders. Specifications and

atures are subject to change without notice or obligation.

DX-WGUSB.fm Page 7 Monday, August 21, 2006 3:20 PM

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules & Canada-Industry Canada (IC)

Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC & IC radiation exposure limits set forth for an uncontrolled

environment.

End users must follow the specific operating instructions for satisfying RF exposure

compliance.

This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

SAR compliance has been established in typical laptop computer(s) with USB port slot, and

product could be used in typical laptop computer with USB port slot. Other application like

handheld PC or similar device has not been verified and may not compliance with related

RF exposure rule and such use shall be prohibited.

Dynex declares that US model of DX-WGUSB (FCC ID: MXF-U950731G) is limited in

CH1-CH11 for 2.4G band by specific firmware controlled by the manufacturer and is not

user changeable.