2-23-11 Draft Installation Manual for Cisco IPTV Receivers for use with your AT&T U-verse TV service Model ISB7005
-23-11 Draft 2
Contents 2-23-11 Draft Notice for Installers ..............................................................................................................4 IMPORTANT SAFETY INSTRUCTIONS .............................................................................4 Change the Way You Watch TV ..........................................................................................6 What’s In the Carton? ......................................................................................................
Notice for Installers 2-23-11 Draft The servicing instructions in this notice are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions, unless you are qualified to do so. Note to System Installer For this apparatus, the cable shield/screen shall be grounded as close as practical to the point of entry of the cable into the building.
IMPORTANT SAFETY INSTRUCTIONS, continued 2-23-11 Draft Handling Disposable Batteries This product may contain disposable batteries. Heed the following warning and follow the Battery Safety and Battery Disposal instructions below. WARNING: There is danger of explosion if the battery is mishandled or incorrectly replaced. Replace only with the same type of battery. Do not disassemble it or attempt to recharge it outside the system.
2-23-11 Draft 6
Change the Way You Watch 2-23-11 TV Draft Welcome to U-verse TV. The ISB7005 devices, known as U-verse receivers, bring a rich, new set of interactive services directly to you through your TV and your in-home IP network. The receiver uses wireless technology 802.11n to connect to the network. The ISB7005 receiver allows for easy and secure connection to U-verse services.
Front Panel 2-23-11 Draft POWER LINK HD RECORD MENU OK ISB7005 1 2 3 1 Power 4 5 6 7 9 10 11 T14820 Turns the receiver on or places it in standby. To restart the receiver, press and hold the POWER button for 10 seconds. The LED is green 2 Model Number Identifies the model number of your receiver as ISB7005 3 Signal Strength Indicator Identifies the strength of the wireless connection 4 Link Indicates network link status.
Back Panel 2-23-11 Draft Pb Y L R TO TV (VIDEO OUT) NETWORK T14821 1 2 Pr 3 S-VIDEO VIDEO OUT AUDIO OUT OPTICAL 4 5 6 7 8 USB POWER 9 10 1 To TV (Video Out) Connect to TV. You must set the channel on your TV to the channel designated by your service provider (usually channel 3).
Connecting the Receiver 2-23-11 Draft To connect your receiver to your network and home entertainment devices, complete these steps. 1 Because the connections for a high-definition (HD) 16 4 or standard-definition (SD) 9 3 or TV are different, you must determine if your TV is HD or SD. Your TV must receive HD signals for you to enjoy the benefits of HDTV. Refer to the manual that came with your TV for more information. See page 26 for more information on picture formats.
ISB7005 Wireless Network Connection 2-23-11 Draft The ISB7005 receiver allows for easy and secure connection to U-verse services. The signal strength indicator on the front panel of the receiver identifies the strength of the wireless connection and aids in the proper placement of the receiver. POWER LINK HD RECORD MENU OK ISB7005 Signal Strength Indicator Wireless LEDs T14822 Receiver Operational Status This indicates the wireless signal is excellent. The video quality is good.
Connections for a High-Defi2-23-11 nitionDraft TV (HDTV) To use the receiver with an HDTV, you must make one of the following connections to view the HD content. Refer to the owner’s manual for your TV and the cabling diagrams in this manual for more detailed connection information. Although all connections provide you with quality service, we list the connections in our recommended order. Notes: • The labeling on your receiver or HDTV may vary slightly from the illustrations shown below.
Connections for a Standard-Defi nition TV (SDTV) 2-23-11 Draft When using the receiver with an SDTV, you must make one of the following connections to view content. Some SDTVs may not have all these connections. Refer to the owner’s manual for your TV and the cabling diagrams in this manual for more detailed information. Although all connections provide you with quality service, we list the connections in our recommended order.
Connections for a VCR or DVD Recorder 2-23-11 Draft When using the receiver with a VCR or DVD recorder, you must make one of the following connections to view content. Although all connections provide you with quality service, we list the connections in our recommended order. Notes: • The labeling on your receiver, VCR, or DVD recorder may vary slightly from the illustrations shown below. • Some cables shown in the connection diagrams may not be included with this receiver.
Connecting to an HDTV with2-23-11 an HDMI Connector Draft Cable Used in this Configuration • 1 HDMI Cable Notes: • The HDMI port on the TV must support high-bandwidth digital content protection (HDCP). • The HDMI interface supports Dolby™ Digital 5.1 audio. WARNING: Electric shock hazard! Unplug all electronic devices before connecting or disconnecting any device cables to the receiver.
Connecting to an HDTV with2-23-11 a DVIDraft Connector Cables Used in this Configuration • 1 HDMI-to-DVI Cable or 1 HDMI Cable and 1 HDMI-to-DVI Adapter • 1 Audio Left/Right Cable (You can also use an optical cable [indicated by the dotted line] instead of the Audio Left/Right Cable as shown in the diagram, dependent upon your TV’s capabilities.) Notes: • The DVI port on the TV must support high-bandwidth digital content protection (HDCP).
Connecting to an HDTV with2-23-11 Component (YPbPr) Connectors Draft Cables Used in this Configuration • 1 Component Video Cable (YPbPr) • 1 Audio Left/Right Cable (You can also use an optical cable [indicated by the dotted line] instead of the Audio Left/Right Cable as shown in the diagram, dependent upon your TV’s capabilities.) WARNING: Electric shock hazard! Unplug all electronic devices before connecting or disconnecting any device cables to the receiver.
Connecting to an SDTV with2-23-11 Component (YPbPr) Connectors Draft Cables Used in this Configuration • 1 Component Video Cable (YPbPr) • 1 Audio Left/Right Cable Note: The receiver must be set to the proper standard-definition mode. WARNING: Electric shock hazard! Unplug all electronic devices before connecting or disconnecting any device cables to the receiver.
Connecting to an SDTV with2-23-11 an S-Video Connector Draft Cables Used in this Configuration • 1 S-Video Cable • 1 Audio Left/Right Cable WARNING: Electric shock hazard! Unplug all electronic devices before connecting or disconnecting any device cables to the receiver.
Connecting to an SDTV with2-23-11 an RCA-Type Connector Draft Cables Used in this Configuration • 1 RCA-type Video Cable • 1 Audio Left/Right Cable WARNING: Electric shock hazard! Unplug all electronic devices before connecting or disconnecting any device cables to the receiver.
Connecting to an SDTV with2-23-11 a Coaxial Cable Draft Cable Used in this Configuration • 1 Coaxial Cable Note: You must set the channel on your TV to the channel designated by your service provider (usually channel 3). Contact your service provider for the channel information. WARNING: Electric shock hazard! Unplug all electronic devices before connecting or disconnecting any device cables to the receiver.
Connecting to a Home Theater System 2-23-11 Draft with Component (YPbPr) Connectors Cables Used in this Configuration • 1 Component Video Cable (YPbPr) • 1 Audio Left/Right Cable (You can also use an optical cable [indicated by the dotted line] instead of the Audio Left/Right Cable as shown in the diagram.) Notes: • This connection requires that audio is provided by the home theater system.
Connecting to a Stereo VCR2-23-11 or DVD Recorder (optional) Draft The diagram below shows how to connect a recording device to your receiver. Although it is possible to watch TV using a connection through your VCR or DVD recorder to the TV, this connection may not provide the best picture, and HDTV users are restricted to an SD format. In addition, some content is copy protected and passing this content through the recording device may result in a picture that cannot be viewed.
Troubleshooting 2-23-11 Draft If the receiver does not perform as expected, the following tips may help. If you need further assistance, contact your service provider. No Picture • Verify that the power to your TV is turned on. • If the receiver is plugged into a wall switch, verify that the switch is in the ON position. • Verify that all cables are properly connected. • If your system includes a VCR, DVD recorder, or stereo, verify that you have properly connected the device to the receiver.
Frequently Asked Questions2-23-11 Draft What Is Digital Television? Digital television (DTV) is a huge leap forward in television technology compared to analog television that has been widely available since the 1940s. DTV is delivered and displayed using digital encoding, similar to the way a PC operates. By using digital technology, there is no variation in picture and sound quality from the origination point until it is displayed on your television.
Picture Formats 2-23-11 Draft What Is the Difference Between a Standard-Screen and a Wide-Screen HDTV? The type of screen your HDTV has (wide-screen or standard-screen) determines how the receiver displays programs on the screen. The picture format for an HDTV is a combination of aspect ratio and screen resolution and is different for standard-screen and wide-screen HDTVs. What Is Aspect Ratio? An aspect ratio is the ratio of the width to the height of the TV screen.
Index 2-23-11 Draft A Connection AC Power input Arrow keys 8 Aspect ratio 26 Audio Out Coaxial Network 11 9 Consumer electronic devices Controls 9, 12, 13, 14 10 See Front panel D B DC Power output Back panel Diagrams. See Connecting the receiver to other devices 9 Burn-in of screen Buttons 24 9 Digital Video Recorder.
Index, continued 2-23-11 Draft K T Keys. See Front panel To Wall (Video In) connector To TV (Video Out) connector N Network Troubleshooting 9, 10, 11 9, 10, 11 9, 13, 21 24 TV O digital, what is it Optical Audio Output 9, 12, 16, 17, 22 Over-the-air converter box formats 14 25 26 HDTV, what is it 25 P programming Picture formats recording 6 Ports. See Connectors resolution 26 Power screen size.
Compliance Information United States FCC Compliance AVC VIDEO LICENSE 2-23-11 Draft With respect to each AVC/H.264 product, we are obligated to provide This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against such interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy.
Federal Communication Commission Interference Statement 2-23-11 Draft This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
2-23-11 Draft 31
2-23-11 Draft Cisco Systems, Inc. 5030 Sugarloaf Parkway, Box 465447 Lawrenceville, GA 30042 678 277-1120 800 722-2009 www.cisco.com © 2011 Cisco and/or its affiliates. All rights reserved.
