User Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- Europe – EU Declaration of Conformity
- Contents
- About this Guide
- Purpose
- Prerequisite Skills and Knowledge
- Conventions Used in this Document
- Help Us to Improve this Document!
- Browan Technical Support
- Chapter 1 – Introduction
- Chapter 2 - Installation
- Chapter 3 – Application Mode
- Chapter 4 – Reference Manual
- Welcome | Wizard
- Welcome | Wizard | Setup Wizard
- Welcome | Notice Board
- Welcome | Password
- Welcome | Wizard
- LAN Settings | Unit Configuration
- LAN Settings | Static DHCP Assignment
- LAN Settings | DHCP lease table
- Wireless Settings | Configuration
- Wireless Settings | Encryption
- Wireless Settings | WDS
- Wireless Settings | WMM
- Wireless Settings | Connection Control
- Wireless Settings | Client List
- Wireless Settings | Advanced
- Wireless Settings | Multiple SSIDs
- Internet Settings | Connection to ISP
- Firewall | Virtual Servers
- Firewall | Special Apps
- Firewall | SPI
- Firewall | QoS
- Firewall | Internet Access Policy
- Firewall | URL Filter
- System Tools | Restart
- System Tools | Time Zone
- System Tools | Configuration
- System Tools | Upgrade
- Advanced | Static Route
- Advanced | RIP
- Advanced | DDNS
- Advanced | Security
- Advanced | Proxy ARP
- Advanced | 1 to 1 NAT
- Advanced | SNMP
- Status and Logs | Status
- Status and Logs | Logs
- Status and Logs | Routing Table
- Status and Logs | Syslog
- Support | Support
- Appendix
BROWAN COMMUNICATIONS Page 56
Enter a new MAC address manually
If the MAC addresses given by the previous two options
are not correct, then you will need to find the MAC
address of the previous device used with your ISP.
Click Back to go to previous screen.
Or Click Next to continue the setup wizard.
Or click Cancel to quit the setup wizard.