User Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- Europe – EU Declaration of Conformity
- Contents
- About this Guide
- Purpose
- Prerequisite Skills and Knowledge
- Conventions Used in this Document
- Help Us to Improve this Document!
- Browan Technical Support
- Chapter 1 – Introduction
- Chapter 2 - Installation
- Chapter 3 – Application Mode
- Chapter 4 – Reference Manual
- Welcome | Wizard
- Welcome | Wizard | Setup Wizard
- Welcome | Notice Board
- Welcome | Password
- Welcome | Wizard
- LAN Settings | Unit Configuration
- LAN Settings | Static DHCP Assignment
- LAN Settings | DHCP lease table
- Wireless Settings | Configuration
- Wireless Settings | Encryption
- Wireless Settings | WDS
- Wireless Settings | WMM
- Wireless Settings | Connection Control
- Wireless Settings | Client List
- Wireless Settings | Advanced
- Wireless Settings | Multiple SSIDs
- Internet Settings | Connection to ISP
- Firewall | Virtual Servers
- Firewall | Special Apps
- Firewall | SPI
- Firewall | QoS
- Firewall | Internet Access Policy
- Firewall | URL Filter
- System Tools | Restart
- System Tools | Time Zone
- System Tools | Configuration
- System Tools | Upgrade
- Advanced | Static Route
- Advanced | RIP
- Advanced | DDNS
- Advanced | Security
- Advanced | Proxy ARP
- Advanced | 1 to 1 NAT
- Advanced | SNMP
- Status and Logs | Status
- Status and Logs | Logs
- Status and Logs | Routing Table
- Status and Logs | Syslog
- Support | Support
- Appendix
BROWAN COMMUNICATIONS Page 26
WAN LED:
1. If the WAN LED is on it indicates the connection
between the BW1230 and your DSL/Cable Modem is
working fine.
2. If the WAN LED is off it indicates the connection is
failed.
3. If the WAN LED is flashing it indicates the
connection between the BW1230 and your
DSL/Cable Modem is working fine and it is
transmitting and receiving the data.
LAN LED (Four Ports) :
1. If the LAN LED is on it indicates the connection
between the BW1230 and your another network
equipment is working fine.
2. If the LAN LED is off it indicates the connection is
failed.
3. If the LAN LED is flashing it indicates the connection
between the BW1230 and your another network
equipment is working fine and it is transmitting and
receiving the data.
3
4