User Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- Europe – EU Declaration of Conformity
- Contents
- About this Guide
- Purpose
- Prerequisite Skills and Knowledge
- Conventions Used in this Document
- Help Us to Improve this Document!
- Browan Technical Support
- Chapter 1 – Introduction
- Chapter 2 - Installation
- Chapter 3 – Application Mode
- Chapter 4 – Reference Manual
- Welcome | Wizard
- Welcome | Wizard | Setup Wizard
- Welcome | Notice Board
- Welcome | Password
- Welcome | Wizard
- LAN Settings | Unit Configuration
- LAN Settings | Static DHCP Assignment
- LAN Settings | DHCP lease table
- Wireless Settings | Configuration
- Wireless Settings | Encryption
- Wireless Settings | WDS
- Wireless Settings | WMM
- Wireless Settings | Connection Control
- Wireless Settings | Client List
- Wireless Settings | Advanced
- Wireless Settings | Multiple SSIDs
- Internet Settings | Connection to ISP
- Firewall | Virtual Servers
- Firewall | Special Apps
- Firewall | SPI
- Firewall | QoS
- Firewall | Internet Access Policy
- Firewall | URL Filter
- System Tools | Restart
- System Tools | Time Zone
- System Tools | Configuration
- System Tools | Upgrade
- Advanced | Static Route
- Advanced | RIP
- Advanced | DDNS
- Advanced | Security
- Advanced | Proxy ARP
- Advanced | 1 to 1 NAT
- Advanced | SNMP
- Status and Logs | Status
- Status and Logs | Logs
- Status and Logs | Routing Table
- Status and Logs | Syslog
- Support | Support
- Appendix
BROWAN COMMUNICATIONS Page 147
System Tools | Restart
Pressing the Restart the Router button will cause the
Router to restart, simulating the effect of power cycling the
unit. No configuration information will be lost. This function
may be of use if you are experiencing problems and you
wish to re-establish your Internet connection.
Any network users who are currently accessing the Internet
will have their access interrupted whilst the restart takes
place, and they may need to reboot their computers when
the restart has completed and the Router is operational
again.