User Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- Europe – EU Declaration of Conformity
- Contents
- About this Guide
- Purpose
- Prerequisite Skills and Knowledge
- Conventions Used in this Document
- Help Us to Improve this Document!
- Browan Technical Support
- Chapter 1 – Introduction
- Chapter 2 - Installation
- Chapter 3 – Application Mode
- Chapter 4 – Reference Manual
- Welcome | Wizard
- Welcome | Wizard | Setup Wizard
- Welcome | Notice Board
- Welcome | Password
- Welcome | Wizard
- LAN Settings | Unit Configuration
- LAN Settings | Static DHCP Assignment
- LAN Settings | DHCP lease table
- Wireless Settings | Configuration
- Wireless Settings | Encryption
- Wireless Settings | WDS
- Wireless Settings | WMM
- Wireless Settings | Connection Control
- Wireless Settings | Client List
- Wireless Settings | Advanced
- Wireless Settings | Multiple SSIDs
- Internet Settings | Connection to ISP
- Firewall | Virtual Servers
- Firewall | Special Apps
- Firewall | SPI
- Firewall | QoS
- Firewall | Internet Access Policy
- Firewall | URL Filter
- System Tools | Restart
- System Tools | Time Zone
- System Tools | Configuration
- System Tools | Upgrade
- Advanced | Static Route
- Advanced | RIP
- Advanced | DDNS
- Advanced | Security
- Advanced | Proxy ARP
- Advanced | 1 to 1 NAT
- Advanced | SNMP
- Status and Logs | Status
- Status and Logs | Logs
- Status and Logs | Routing Table
- Status and Logs | Syslog
- Support | Support
- Appendix
BROWAN COMMUNICATIONS Page 118
DNS Addresses:
If your ISP has provided you with DNS addresses, you
should enter them here. Otherwise, leave these setting
at its default of 0.0.0.0. These settings are optional,
and most ISP's will also provide you with DNS
addresses automatically. When the addresses are
obtained from your ISP, they will be displayed on the
Status screen.
MTU:
The MTU settings should be obtained from your
Internet Service Provider. If you do not know this value,
just leave it at the default value.
Get IP By DHCP:
Some ISP may have the mechanism that automatically
provides Initial IP Address, Subnet Mask and Default
Gateway. If your ISP provides such mechanism, you
should check this option. Otherwise, you should
manually enter your initial IP Address, Subnet Mask
and Default Gateway.