User Manual
Table Of Contents
- Copyright
- Notice
- Trademarks
- Europe – EU Declaration of Conformity
- Contents
- About this Guide
- Purpose
- Prerequisite Skills and Knowledge
- Conventions Used in this Document
- Help Us to Improve this Document!
- Browan Technical Support
- Chapter 1 – Introduction
- Chapter 2 - Installation
- Chapter 3 – Application Mode
- Chapter 4 – Reference Manual
- Welcome | Wizard
- Welcome | Wizard | Setup Wizard
- Welcome | Notice Board
- Welcome | Password
- Welcome | Wizard
- LAN Settings | Unit Configuration
- LAN Settings | Static DHCP Assignment
- LAN Settings | DHCP lease table
- Wireless Settings | Configuration
- Wireless Settings | Encryption
- Wireless Settings | WDS
- Wireless Settings | WMM
- Wireless Settings | Connection Control
- Wireless Settings | Client List
- Wireless Settings | Advanced
- Wireless Settings | Multiple SSIDs
- Internet Settings | Connection to ISP
- Firewall | Virtual Servers
- Firewall | Special Apps
- Firewall | SPI
- Firewall | QoS
- Firewall | Internet Access Policy
- Firewall | URL Filter
- System Tools | Restart
- System Tools | Time Zone
- System Tools | Configuration
- System Tools | Upgrade
- Advanced | Static Route
- Advanced | RIP
- Advanced | DDNS
- Advanced | Security
- Advanced | Proxy ARP
- Advanced | 1 to 1 NAT
- Advanced | SNMP
- Status and Logs | Status
- Status and Logs | Logs
- Status and Logs | Routing Table
- Status and Logs | Syslog
- Support | Support
- Appendix
BROWAN COMMUNICATIONS Page 101
Threshold too low may result in poor network performance.
Only minor reduction of the default value is recommended.
In most cases, it should remain at its default value of 2346.
RTS Threshold
Should you encounter inconsistent data flow, only minor
reduction of the default value, 2347, is recommended. If a
network packet is smaller than the preset RTS threshold
size, the RTS/CTS mechanism will not be enabled. The
Router sends Request to Send (RTS) frames to a particular
receiving station and negotiates the sending of a data
frame. After receiving an RTS, the wireless station
responds with a Clear to Send (CTS) frame to acknowledge
the right to begin transmission. The RTS Threshold value
should remain at its default value of 2347.