User Manual Part 3

User’s Guide Version 1.0
Keep in mind that resetting the device is an irreversible process.
Please note that even the administrator password will be set back to the factory
default.
Reboot – reboot device with the last saved configuration.
System | Update
Check for new product updates at the Browan Communications website:
http://www.browan.com
To update your device firmware, use only the original firmware image and under system | update
menu click the upload button:
Figure 204 – Firmware Update
Specify the full path to the new firmware image and click the upload button:
Figure 205 – New Firmware Upload
Firmware Image – enter the firmware image using the full path.
Browse – click the button to specify the new image location.
Upload – upload with new firmware.
Cancel – cancel the upload process.
New firmware image is uploaded into the controller. Now you need to upload this new firmware into
the controller’s FLASH memory, click the flash button:
Figure 206 – Flash New Image
Flash – flash new image, reboots the system.
Do not switch off and do not disconnect the BW1330 from the power supply during
the firmware update process because the device could be damaged.
BROWAN Page
113