User Manual Part 3

User’s Guide Version 1.0
BROWAN Page
Switch control dedicated port: disabled/LAN1/LAN2/LAN3/LAN4.
Needed only with actions A and E.
<dedicate>
network dhcp
<interface> Interface name for DHCP server instance.
Status of DHCP server for interface. May be server, relay or
disabled.
-s <status>
Start of IP address range supported for DHCP service. Needed
only with server status.
-f <from>
End of IP address range supported for DHCP service. Needed
only with server status.
-t <to>
WINS Address (Windows Internet Naming Service Address) if it is
available on the network. Needed only with server status.
-w <wins>
-l <lease_time> DHCP Server lease time. Needed only with server status.
-d <domain> DHCP domain name. Needed only with server status.
Circuit ID - a unique NAS identifier. MAC address will be used by
default. Needed only with relay status.
-c <circuit_id>
-n <dns_list> List of up to two DNS servers IP addresses.
network dns
-p <nameserver> DNS primary Server IP address.
-s <nameserver> DNS secondary Server IP address.
-d <nameserver> DNS Domain Name.
-h <nameserver> DNS Host Name.
Network Radius Commands
network radius
accounting_log For sending RADIUS accounting via syslog.
proxy RADIUS Proxy configuration.
servers Up to 32 different RADIUS servers' configuration.
settings General RADIUS settings configuration.
wisp WISP information and setup.
network accounting_log
Remote accounting log status. Possible values are enabled or
disabled.
-r <status>
-a <host> The host IP address where to send the accounting information.
network radius proxy
-s <status> RADIUS Proxy status: enabled or disabled.
-a <port> RADIUS Proxy authentication port.
-c <port> RADIUS Proxy accounting port.
-t <time> RADIUS Proxy accounting detection timeout
network radius servers
accounting Accounting RADIUS servers' configuration.
authentication Authentication RADIUS servers' configuration.
backup Accounting information backup servers configuration.
network radius servers
133