User Manual Part 2

User’s Guide Version 1.0
Figure 188– SNMP Settings
SNMP Table:
SNMP Service – enable or disable SNMP service on AC [enabled/disabled]. By default SNMP service
is enabled. With service enabled the AC acts as the SNMP agent.
If enabled, then device can be configured via SNMP:
SNMP Name – An administratively assigned name for this managed node [0-99 any string]. By
convention, this is the node’s fully qualified domain name.
SNMP Location – The physical location of this node (e.g., `telephone closet, 3rd floor') [0-99 any
string].
SNMP Contact – The textual identification of the contact person for this managed node, together with
information on how to contact this person [0-99 any string].
SNMP Read-Only Community – Community name is used in SNMP version 1 and version 2c. Read-
only (public) community allows reading values, but denies any attempt to change values [1-32 all
ASCII printable characters, no spaces].
SNMP Read-Write Community – Community name is used in SNMP version 1 and version 2c.
Read-write (private) community allows to read and (where possible) change values [1-32 all ASCII
printable characters, no spaces].
Default Trap Community Name – The default SNMP community name used for traps without
specified communities. The default community by most systems is "public". The community string
must match the community string used by the SNMP network management system (NMS) 1-32 all
ASCII printable characters, no spaces].
Authentication Failure Taps Generation – select [enable/disable] getting the authentication failure
traps from your AC.
SNMP Users Table:
SNMP Users table is only used for SNMP v3.
BROWAN Page
107