User Manual Part 2

User’s Guide Version 1.0

for a better performance. 2.4GHz (11g only) mode only allows 11g client access. 2.4GHz(Mixed 11g)

mode allows 11b/11g client access.2.4GHz(Mixed 11g WiFi) or 2.4GHz(11g only WiFi) can make sure

to compatible with Wi-Fi.

Tx Power – the BW1330 transmission output power in dBm. Different power level is based on domain

setting. Default is 18dBm&WORLD.

Total Output Power (EIRP) = Antenna Gain + RF card output power

The range of the EIRP varies with channel and regulatory domain.

RTS Threshold – when set, this settings specifies the maximum packet size beyond which RTS/CTS

mechanism is be invokes. The value range of this is [0 …2347]. Default is 2347 which means that

RTS is disabled.

DCA threshold – show the value (in minutes) of DCA threshold. This threshold is been used to judge

if there is no wireless users connected during this time. And if yes, BW1330 will monitor the

environment and adjust channel for the best operational one.

DCA optional channel – show the channels only in which auto channel selection (DCA) will be

processed to reduce interference.

Only when DCA is enabled, DCA threshold and DCA optional channel will be

shown.

Layer 2 Isolation – Layer2 wireless client separation. Connected clients with user isolation function

enabled cannot access each other directly. The clients are isolated from each other using their MAC

addresses [enabled/disabled].

Mode – the operating of Access Point[AP].

For such each change of settings, the BW1330 needs to be reboot to apply all settings changes when

clicking Apply Changes. Request for reboot server appears:

Figure 128 – Configuration changed

Figure 129 – Click apply changes button and reboot device

BROWAN Page

2.33 dBi

20 dBm

2.33 dBi