User Manual Part 1

User’s Guide Version 1.0
Chapter 8 – Reference Manual
This chapter contains BW1330 web management reference information.
The web management main menu consists of the following sub menus:
 Network Interface – device configuration settings affecting networking.
 User Interface – device configuration settings affecting the user interface.
 System – device system configuration settings directly applicable to the controller.
 Connection– device settings related to user’s connection with the BW1330.
 Built-In AAA – Built-in AAA system for web authentication and accounting.
 Exit – click exit and leave the web management then close your web-browser window.
Web Interface
The main web management menu is displayed at the top of the page after successfully logging into
the system (see the figure below). From this menu all essential configuration pages are accessed.
Figure 67 – Main Configuration Management Menu
By default the system | status menu is activated and the current AC system status is displayed. The
active menu is displayed in a different color.
The web management menu has the following structure:
Network Interface
Configuration – configuration page for all controller network interfaces
Interface configuration – network interfaces configuration
Bridge – bridge configuration
VLAN – define VLAN on your controller
Route – define new static route on the controller interface
Port forwarding – port-forwarding rules
DHCP Relay – DHCP relay server configuration
User ACL – define packet filter rules
Management subnet – access points (APs) management
DNS – define DNS server settings
DHCP – Dynamic Host Configuration Protocol services configuration
POP3 – POP3 server address configuration for client authentication
RADIUS – configuration set for RADIUS servers, includes menu:
RADIUS settings – NAS server ID, hotspot operator name and other settings
RADIUS servers – accounting, authentication RADIUS servers IP, port and other settings
WISP – add new WISP on the system.
Proxy – configure the AC to act as RADIUS server proxy.
Accounting backup – backup authentication logs in the remote or external server
Tunnels – set tunnels:
PPPoE/ GRE for DSL – connect to ISP via the PPPoE or GRE tunnel
GRE Client for VPN – set the GRE (Generic Routing Encapsulation) tunnels for the BW1330
Wireless – wireless interface configuration
Basic – primary SSID, regulatory domain, network mode, channels selection
Advanced – multiple SSID configuration
WDS – access point and WDS modes
SecWep – WEP and WPA
User Interface
Configuration –Welcome/Login/Logout/Help page customization
Pages – configure and upload user pages
BROWAN Page
57