User Manual Part 1

User’s Guide Version 1.0
System
System is a category of commands that configures access to controller (telnet, AAA methods, L2
isolation, SNMP, UAT) and configuration: clock, NTP, pronto, syslog, trace and firmware upgrade.
A list of all available system commands/subcommands and their parameters are
available in the Appendix section:
C) CLI Commands and Parameters.
In general, the system command usage is as follows:
system <command> <subcommand1> <subcommand2> [-parameter] <value>
To get the full list of the system commands, type:
system
Figure 64 – System Commands List
Telnet
To make a telnet connection, type the telnet command in the command line:
telnet
The telnet client is activated and ready for a telnet session.
Figure 65 – Telnet Session
Quit the telnet to return to CLI interface.
Reboot
To stop the controller and reboot the device, type the reboot command in the command line. No
configuration changes are done. The last saved configuration is applied to the rebooted controller.
Reset
To reset the controller to factory defaults, type the reset command. The device is restarted and
defaults values are set.
Please note that even the administrator password will be set back to the factory
default.
Exit
To leave the CLI mode, type the Exit command in the command line.
BROWAN Page
53