User Manual

VPN Gateway: Assign this VPN as default route
Local Secure Group and Remote Secure Group.
The Local Secure Group is the computer(s) on your LAN that can access the tunnel.
Local Secure Group defines the endpoint on local
site. It can be one IP address,
IP Range, Subnet, or NONE (Host).
From the drop-down
menu, select Subnet, to include the entire network for the tunnel; select IP Address if you want a
specific
computer; IP Range, if you want to include a range of IP addresses; or select Host, which is used
with Port
Forwarding to direct the traffic to the correct computer. The screen will change depending on the
selected
option. The options are described below.
Figure 6-21: VPN
Figure 6-22: Subnet
Subnet. Enter the IP Address and Mask of the local VPN Router in the fields. To allow access to
the entire IP
subnet, enter 0 for the last set of IP Addresses. (e.g. 192.168.1.0).
IP Address. Enter the IP Address of the local VPN Router in the fields. The Mask will be displayed.
IP Range. Enter the starting and ending numbers for the IP Address range in the fields.
Host. The VPN Tunnel will terminate at the router with this setting. Use Port Range Forwarding to
direct traffic
to the correct computer. Refer to the Port Range Forwarding tab of the Applications and Gaming
tab.
The Remote Secure Group is the computer (s) on the remote end of the tunnel that can
access the tunnel.
Remote Secure Group defines the endpoint on
remote site. It also support ANY remote local
style.
From the drop-down menu, select Subnet, to include the entire network for the tunnel; select IP
address if
you want a specific computer; IP Range, if you want to include a range of IP addresses; select
Host, if the VPN
will terminate at the Router, instead of the PC; or Any, to allow any computer to access the tunnel.
The screen
will change depending on the selected option. The options are described below.
Subnet. Enter the IP Address and Mask of the local VPN Router in the fields. To allow access to
the entire IP
subnet, enter 0 for the last set of IP Addresses. (e.g. 192.168.1.0).
IP Address. Enter the IP Address of the local VPN Router in the fields. The Mask will be
displayed.
IP Range. Enter the starting and ending numbers for the IP Address range in the fields.
• Remote Security Gateway.
Remote Secure Gateway specify the
remote gateway location. It can be IP addr, FQDN,
or ANY.
The Remote Security Gateway is the VPN device, such as a second VPN Router, on
the remote end of the VPN tunnel. Enter the IP Address of the VPN device at the other end of the