User's Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. Setup
- 4.PC Configuration
- 5. Operation and Status
- 6. Advanced Features
- 7. Advanced Configuration
- Appendix A Troubleshooting
- Appendix B About Wireless LANs
- Appendix C Specifications
2. Installation
This Chapter covers the physical installation of the Wireless Router.
2.1 Requirements
• Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors.
• TCP/IP protocol must be installed on all PCs.
• For Internet Access, an Internet Access account with an ISP, and either of a DSL or Cable
modem (for WAN port usage)
• To use the Wireless Access Point, all Wireless devices must be compliant with the
IEEE802.11b specifications.
2.2 Procedure
Figure 4: Installation Diagram
1. Choose an Installation Site
Select a suitable place on the network to install the Wireless Router.
Ensure the Wireless Router and the DSL/Cable modem are powered OFF.
8
For best Wireless reception and performance, the Access
Point should be positioned in a central location with mini-
mum obstructions between the Access Point and the PCs.
Also, if using multiple Access Points, adjacent Access
Points should use different Channels.