User Manual

WX-5525R Dual Band AP Router
Wireless Broadband Anywhere
4
Hardware Installation
Front Panel
The front panel provides LED’s for device status. Refer to the following
table for the meaning of each feature.
LED STATUS Description
Off No Power
Red On 1. Power on 2. Reset to default 3. Firmware upgrade (first 1 minute)
PWR/STAT
Red Blink 1. System up 2. Power on 3. Firmware upgrade
Off no Ethernet link detected
LAN Green On 10/100Mbps Fast Ethernet link detected. No activity.
Green Blink Indicates data traffic on the 10/100 Mbps LAN
Orange On 10Mbps Ethernet link detected. No activity.
WAN
Orange Blink Indicates data traffic on the 10 Mbps WAN.
G Yellow Blink Indicates the device is linking or active data through wireless links
Rear Panel
The rear panel features 4 LAN ports, 1 WAN port and Reset button.
Refer to the following table for the meaning of each feature.
Power
(DC 5v)
Used to connect to the power outlet. Only use the power adapter
provided with the device. Use of an unauthorized power adapter
may cause damage to your device and violate your warranty.
Reset Press the Reset Button for approximately ten seconds, all
configurations will set to factory default settings.
LAN The RJ-45 Ethernet ports used to connect your PC, hub, switch or
Ethernet network.
WAN The RJ-45 Ethernet port labeled WAN is used to connect your AP
Router to your xDSL or Cable modem.