User Manual

P380 Users guide

Configuring SNMP management

SNMP (Simple Network Management Protocol) service is configured in the SNMP

Settings page. This page is used for setting up read-only and read-write communities:

Figure 24: SNMP Settings

Community strings are used for SNMP authentication purposes. It is possible to allow or

deny IP address groups from accessing P380 using SNMP. IP address and netmask

combination 0.0.0.0/32 means “ANY” IP address. It could be setup by a specified IP, ex

192.168.2.100/32, or by a group, ex 192.168.2.0/24.

i Hint: For security purposes, use only local IP addresses for Read/Write access

Click on the “Reset” button to reset all page fields to their default values and click on the

“Save Settings” button to save the SNMP setting.