User Manual

P380 Users guide

i Hint: above figure shows default system routes, which are added automatically, and

restored after any network configuration. However these routes can be edited for

temporary needs.

This page provides a user static route list (present on the system), and ability to edit,

delete and add routes. Rule editing and adding is done in the following page:

Note: In AP and Bridge mode P380 has no active LAN (Local Area Network) interface,

so the “Static Routes” page is not displayed

Figure 17: Route editing table

Each rule in the route list consists of Device (interface) selection (can be wireless or

Ethernet), Destination address (depending on netmask, can be a host or sub net), Gateway

address (if not specified, program uses default interface gateway), Metric (route priority),

and Netmask. If netmask is specified as 255.255.255.255, then routing program assumes

that it is the “host” route type; otherwise route specifies “net”. Note that routes are

automatically enabled when the “Save Route” button is pressed. If a rule is specified

incorrectly, no warning is provided, but rule is not added to the system. Only skilled

network administrator with in-depth knowledge of the network topology should use the

static routing feature.