User's Manual

P380 Users guide

measured by sending ICMP (Internet diagnostics protocol) stream to the end point device.

Data is refreshed every second.

To start loopback testing, enter endpoint IP address in the “Endpoint IP address” field

and click on the “Start” button in the lower right corner of the page. Status line will show

last measured data transfer rate, and the time when this data was received from the

endpoint. To stop loopback-testing, click on the “Stop” button.

~Note: Due to the nature of this test, test data is stored in the web browser applet area.

Clicking the “Refresh” or “Back” buttons when test is running will stop the test and

clear the collected test data.