User Manual

14
DIAL-UP
MODEM
Port used to connect an external analog backup
modem/ISDN TA.
RESET
Resets the configuration to default settings.
Local Ethernet
1 , 2, 3, 4
The RJ-45 Ethernet ports used to connect your PC or
HUB , The Ethernet Cable used can be normal Ethernet
cables or even Crossover Cable.
The 714 have internal AutoCrossover detection circuit to
automatic identify them.
Basic DI-714 Configuration & Main Page
The DI-714 provides a Web Configuration interface that can be
accessed using standard web browsers such as Netscape Communicator or
Microsoft Internet Explorer. Since the interface is web based (HTTP), the
DI-714 can be configured with any Java and HTML compliant Internet
browser in any operating system. This section will discuss the Web
Configuration interface and how to use different options and settings.
Although you can change the IP address of the DI-714 to meet your
needs, this manual will assume that the defaults are left in place. This
means that the IP address of your DI-714 will be 192.168.0.1. If you have
changed the IP address scheme, please substitute 192.168.0.1 with the IP
address scheme that you have chosen.
Start-up and Log in
In order to configure the DI-714, you must use your web browser and
manually input 192.168.0.1 into the Address box and press Enter. The
Main Page will appear. The Device Information and Device Status
screens can be seen without logging into the DI-714. However, when the
Setup Wizard, Basic Setup, Advanced Settings and System Tools buttons