User Manual

13
Side Panel
The power port is located on the right-hand side of the DI-714. Connect
the AC adapter to this port to supply power.
Front Panel
The front panel provides LED’s to indicate the device’s status. Refer to
the following table for the meaning of each feature.
Power
Power status of the DI-714. A steady LED indicates that
the power is on. No LED lights indicate lack of power.
Status
Router status indicates. When router boot or Flash memory
writing Status LED should be blinking.
Broadband
Wide Area Network status. When connected to the
Cable/DSL modem, the LED should be on.
Dial-Up
Indicates Dial-UP Modem port their Carrier Detect status.
When modem connection is established then LED should be
steady on.
Wireless
Indicates wireless initial ready status. When wireless AP
initial ready, the LED should be steady on.
Local
Ethernet
1,2,3,4
Link/ACT = Displays Link Activity.
When each of LAN port connects to PC or HUB, Link/ACT
should be steady on, when data transfer then Link/ACT
should be blinking.
Rear Panel
The rear panel features a LAN port, WAN port ( BroadBand) ,Serial
Modem port and Factory Reset button. Refer to the following table for the
meaning of each feature.
5V DC
Used to connect to the power outlet. Only use the power
adapter provided with the DI-714. Use of an
unauthorized power adapter may cause damage to your
device and violate your warranty.
BROADBAND
The RJ-45 Ethernet port labeled BroadBand is used to
connect your DI-714 to your xDSL or Cable modem.