User Manual

............................................................................................................................................................................................................................................................
To install the CellPipe 7130 RGHardware installation
2-2
3FE-63398-AAAA-TCZZA
Edition 01 April 2009
............................................................................................................................................................................................................................................................
Figure 2-1 Cable connections
Procedure
1. Connect the power adapter jack into the power socket on the CellPipe 7130 RG and
plug the power adapter plug into an outlet.
2. Connect one end of the RJ-45 cable into the VDSL port on the CellPipe 7130 RG and
the other end to your telephone/DSL service connection.
3. If you have VoIP, connect your phone(s) to the phone port(s) on the CellPipe 7130 RG.
4. Connect one end of the RJ-45 Ethernet cable to the Ethernet LAN port (1 to 4) on the
CellPipe 7130 RG and the other end to your Ethernet PC (or LAN hub if you are
setting up an intranet).
5. Turn the power switch on.
........................................................................................................................................................
E ND OF STEPS
You must also configure the Internet properties on your Ethernet PC; see the TCP/IP
Appendix or Quick Installation Guide for detailed instructions.
After setting up and configuring the CellPipe 7130 RG and your PC(s), you can access the
web configuration tool.