User Manual
Table Of Contents
- index.html
- features.html
- install.html
- pci-install.html
- pc-install.html
- connection.html
- utility.html
- utilityintro.html
- troubleshooting.html
- trouble1.html
- trouble2.html
- trouble4.html
- trouble5.html
- trouble7.htm
- trouble9.html
- trouble11.html
- trouble16.html
- trouble17.htm
- trouble18.html
- trouble20.html
- trouble21.html
- trouble22.html
- warranty.html
- support.html
- faq.html
- regulatory.html
- copyright.html
Wireless Nd1 Router User Guide
Possible Solution:
Be sure that each Wireless Nd
1
PC Card or PCI Adapter that you want to connect to the
wireless network is set to Infrastructure mode within the Configuration Utility. If your
Wireless Nd
1
PC Cards or PCI Adapters are not set to Infrastructure mode, they will not
be able to communicate with an access point or wireless router.
Possible Solution:
Determine the WLAN MAC address of the desired wireless router or access point. The
WLAN MAC address is usually located on a label on the wireless routers and access
points. Check the WLAN MAC address and verify that you are connecting to the correct
wireless router or access point.
Return to Troubleshooting page
© 2005-2006 U.S. Robotics Corporation
file:///G|/CSO/Documentation/Documentation%20-%20Dra...ch-1%20PCI%20Card/User%20Guide/english/trouble9.html (3 of 3)10/19/2006 12:14:35 PM