User Manual

Wireless Nd1 PC Card and PCI Adapter
1. Open the USRobotics Wireless Nd
1
Configuration Utility and select the Wireless
Networks tab.
2. Pull down the Add menu and select Use Wizard. Select a wireless network from
the list and click Next.
3. If security is enabled for the specified wireless network device, enter the Network
key, click Next, and then Connect. If security is not enabled for the specified
wireless network device, click Connect.
4. You should now be connected to the specified wireless network device.
Using the Configuration Utility
1. Open the USRobotics Wireless Nd
1
Configuration Utility and select the Wireless
Networks tab.
2. Pull down the Add menu and select Use Utility.
3. Click Select to display a list of wireless devices.
4. Select a wireless device.
5. If you do not see the correct device, click Refresh to update the list. If you still do
not see the correct device, click Cancel and manually enter the Network Name of
the device.
6. Click Ok.
7. Enter the appropriate connection and security information for the wireless network
device, if applicable, and click OK.
8. Click OK and the Nd
1
PC Card or PCI Adapter will attempt a connection to the
wireless network. If the card or adapter does not connect to the wireless network,
open the Wireless Networks tab in the in the Configuration Utility, select the
wireless network, and click Edit. Verify that the information for the wireless
network device is correct and click OK.
© 2005-2006 U.S. Robotics Corporation
file:///G|/CSO/Documentation/Documentation%20-%20Dra...-1%20PCI%20Card/User%20Guide/english/connection.html (3 of 3)10/19/2006 12:14:32 PM