User's Manual

■ chapter 2 bios setup and security feature
Normally use Auto To let BIOS decide the PIO mode setting.
If the selected PIO mode is not supported by the IDE drive, the
hard disk drive may not work properly.
 S.M.A.R.T. Mode:
Self-diagnostic and self-monitoring features are built into newer
type hard drive. Select Auto to enable S.M.A.R.T.
 DMA Mode:
The hard drive in your computer support Ultra DMA mode.
 Block Multi-Sector Transfer:
The hard drive in your computer support Multi-sector data
Transfer.
Note: AMIBIOS automatically sets IDE drive parameters. Select Auto whenever
possible. An incorrect setting make cause the computer to malfunction.
Boot Setup
►Boot Device Priority
Item Selections /
Sub-menu
Description
1st Boot
Device
Set the type of device for the 1st drive
BIOS attempts to boot from. If NSC
MacPhyter is selected, system will
attempt to load boot sector from the
Ethernet port.
2nd Boot
Device
Set the type of device for the 2nd drive
BIOS attempts to boot from.
3rd Boot
Device
ATAPI CDROM
Hard Drive
??NSC
DP83815/6
MacPhyter??
Disabled
Removable Dev.
Set the type of device for the 3rd drive
BIOS attempts to boot from.
2-6