User Manual

Appendix A Regulatory Compliance Notices
Motion Computing M1200 and M1300 Tablet PC User Guide ii
FEDERAL
COMMUNICA-
TIONS
COMMISSION
NOTICE
Unintentional Emitter per FCC Part 15
The rating label on the Motion M1200 and M1300 Tablet PCs and
Motion M-Series FlexDock shows which class (A or B) these devices
fall into. Class B devices have an FCC logo ( ) or FCC ID on the label.
Class A devices do not have an FCC ID on the label. Once you
determine the class of the device, refer to the following corresponding
statement and to the FCC notices in this Appendix.
• Class A is for business or industrial environments.
• Class B is for residential environments.
This device complies with Part 15 of the Federal Communications
Commission (FCC) Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including
interference that may cause undesired operation.
Class A Equipment: This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated
in a residential environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the manufacturer’s instruction manual, may cause
interference with radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference, in which case
you will be required to correct the interference at your own expense.
Class B Equipment: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated
in a residential environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the manufacturer’s instruction manual, may cause
interference with radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
you are encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected