User's Manual

Wizards
Using the Wireless Wizard to Configure the Wireless Settings for ISA550W and ISA570W
Cisco ISA500 Series Integrated Security Appliance Administrator Guide 41
2
• Configuring the SSID for Intranet WLAN Access, page 43
• Configuring the SSID for Guest WLAN Access, page 44
• Configuring the SSID for Guest WLAN Access (Captive Portal), page 45
Using the Wireless Wizard to Configure the Wireless Settings
STEP 1 Click Wizards -> Wireless Wizard.
The Getting Started window opens.
STEP 2 Click Begin.
The Wireless Radio Setting window opens. Enter the following information:
• Wireless Network Mode: Specify the Physical Layer (PHY) standard that
the wireless radio uses.
- 802.11b only: Choose this mode if all devices in the wireless network
use 802.11b. Only 802.11b clients can connect to the access point.
- 802.11g only: Choose this mode if all devices in the wireless network
use 802.11g. Only 802.11g clients can connect to the access point.
- 802.11b/g mixed: Choose this mode if some devices in the wireless
network use 802.11b and others use 802.11g. Both 802.11b and 802.11g
clients can connect to the access point.
- 802.11n only: Choose this mode if all devices in the wireless network
can support 802.11n. Only 802.11n clients operating in the 2.4 GHz
frequency can connect to the access point.
- 802.11g/n mixed: Choose this mode to allow 802.11g and 802.11n
clients operating in the 2.4 GHz frequency to connect to the access point.
- 802.11b/g/n mixed: Choose this mode to allow 802.11b, 802.11g, and
802.11n clients operating in the 2.4 GHz frequency to connect to the
access point.
• Wireless Channel: Choose a channel or choose Auto to let the system
determine the best channel to use based on the environmental noise levels
for the available channels.
STEP 3 After you are finished, click Next.
The Choose SSIDs window opens. From this page you can enable the SSIDs and
choose the wireless connectivity type for each active SSID.