User's Manual

Wizards
Using the Wireless Wizard to Configure the Wireless Settings for ISA550W and ISA570W
Cisco ISA500 Series Integrated Security Appliance Administrator Guide 44
2
• VLAN Mapping: Choose the VLAN to which the SSID is mapped. All traffic
from the wireless clients that are connected to this SSID will be directed to
the selected VLAN. For Intranet VLAN access, you should choose a VLAN
that is mapped to a trust zone.
• User Limit: Specify the maximum number of users that can simultaneously
connect to this SSID.
Configuring the SSID for Guest WLAN Access
This section describes how to configure the connectivity settings for Guest WLAN
access.
STEP 1 After you are finished the SSID1 configuration, click Next.
If SSID2 is enabled and is set to Guest WLAN Access, the SSID2 window opens.
STEP 2 Enter the following information:
• SSID: Enter the SSID name.
• Broadcast SSID: Check the box to broadcast the SSID in its beacon frames.
All wireless devices within range are able to see the SSID when they scan
for available networks. Uncheck the box to prevent auto-detection of the
SSID. In this case, users must know the SSID to set up a wireless connection
to this SSID.
• PC Visibility: Check the box so that the wireless clients on the same SSID
are able to see eachother.
STEP 3 In the Security Settings area, specify the wireless security settings.
• Security Mode: Choose the security mode and configure the
correspoinding information. For the complete details for how to configure the
security modes, see Configuring the Security Mode, page 162.
STEP 4 In the Advanced Settings area, enter the following information:
• VLAN Mapping: Choose the VLAN to which the SSID is mapped. All traffic
from the wireless clients that are connected to this SSID will be directed to
the selected VLAN. For Guest VLAN access, you should choose a VLAN that
is mapped to a guest zone.