User's Manual

HGW LED definition

LED Color(S) Activity Description

Power (TOP)

Green

Solid Power on(self test succeeded)

flash Device POSTING and BOOTING

Off Power Off

Red

Solid

 POST fails on startup (example, flash is corrupt). So in Hardware the LED should be

RED by default until the software is running which can then turn it green. Normally

the ONT should also do a self-test on power-up. If Self-test fails the LED should

remain RED

 During operations the ONT fails (Device Malfunction): On regular intervals the ONT

should run a self-test and if it fails the LED should turn RED.

flash Firmware upgrade ongoing

Off System is in normal condition

RPF (TOP)

Green Solid reverse power active

Amber Solid reverse power in detection mode

Off Off reverse power is off

G.fast/Vplus-

VDLS2

(TOP)

Green

Solid Provisioned and registered(VDSL2)

flash

 Flashing at 2 Hz with a 50% duty cycle: DSL carrier detection ongoing;

 Flashing at 4 Hz with a 50% duty cycle: Carrier has been detected, DSL training is

ongoing;

Off not provisioned

Amber

Solid Provisioned and registered(Gfast/Vplus)

flash

 Flashing at 2 Hz with a 50% duty cycle: DSL carrier detection ongoing;

 Flashing at 4 Hz with a 50% duty cycle: Carrier has been detected, DSL training is

ongoing;

Off not provisioned