User's Manual

Change Between Client and Ad Hoc Modes

To change between Client and Ad Hoc Modes, simply access the Web User Interface, select Setup,

and follow the on-screen instructions as demonstrated in the graphics below:

Upgrading Your Adapter

Download and place the firmware file to a local directory. Place the 5430 in Configuration Mode

(hold the reset switch for 6 seconds). Connect the Ethernet cable to your computer’s Ethernet

port and release and renew your computer’s IP address (refer to the Accessing the 5430’s Web

User Interface pages in this User Guide for more information). Launch an Internet browser and

enter http://192.168.1.201 in the address line. Enter the username (the default username is

admin) and the password (the default password is admin) to access the Tools menu. Browse the

directory where the downloaded firmware file was placed and start the upgrade. It is important

that you do no unplug the cable or interrupt the upgrade. Allow several minutes for the adapter

to reboot after the upgrade.

R24.0451.00 5430 English Install.fm Page 7 Wednesday, February 4, 2004 5:20 PM