User's Manual

How do I change my network association?

Possible Solution:

To change your network association, select To ol s from the Menu bar. Select Site Survey. A sepa-

rate window will appear listing all of the networks surveyed by the 5430. Select the correspond-

ing network and click Select. Select Setup from the Menu bar. Follow the on-screen instructions

to configure your 5430.

The wireless LED is not on.

Possible Solution:

If the wireless LED is not illuminated you obviously do not have a wireless connection. verify

your AC power adapter is properly connected and that your Ethernet cable is properly connected

as well. You may also have experience low link quality. Refer to the link quality troubleshooting

question to determine if you are experiencing interference issues.

Possible Solution:

You may need to refresh the IP settings on your computer. To do so, you need to place the 5430

in Configuration Mode, if you haven’t done so already. To put the 5430 in Configuration Mode,

simply press the reset button for less than 5 seconds. You should be able to access the Web User

Interface pages. Access the Web User Interface by opening an Internet browser and entering

http://192.168.1.201 in the address field. If your search for the device times-out or you do not

get a dialog box for the user name and password, you may need to refresh the IP settings on your

computer. Select your corresponding operating system to refresh the IP settings.

Windows 95, 98, or Me Users:

Click Windows Start and then Run. Type winipcfg and click OK. Check the IP Address, Subnet

Mask, Default Gateway, and DNS server data to make sure they are correct. If the information is

not correct, click Release All and then click Renew All.

Windows NT, 2000, or XP Users:

Click Windows Start and then Run. Type cmd and click OK. At the DOS prompt, type

ipconfig /all. Check the IP Address, Subnet Mask, Default Gateway, and DNS server data to make

sure they are correct. If the information is not correct, type

ipconfig /release and press Enter. Then, type ipconfig /renew and press Enter.

My wireless router does not appear in the site survey window when I perform a site survey.

Possible Solution:

You may be on a computer that is physically too far away from the 5430. Try moving closer to the

5430 and repeating the scan procedure. Check any physical connections between the 5430 and

your modem, router, hub, LAN, or switch.

R24.0451.00 5430 English Install.fm Page 11 Wednesday, February 4, 2004 5:20 PM