User's Manual

P-720 User’s Guide v1.0 Jun 10, 2005
Page 28 of 51
Figure 31 – Apply or Discard Basic Wireless Settings
Radio – specify which wireless interface of P-720 is shown
Channels – select the channel that the access point will use to transmit and receive information. If
one channel is defined, it acts as default channel. Channels list will vary depending on selected
regulatory selected band. Multiple frequency channels are used to avoid interference
between two radios of this AP, and between nearby access points. If you wish to operate more than
one access point in overlapping coverage areas, we recommend a distance of at least four channels
between the chosen channels. For example, for three Access Points in close proximity choose
channels 1, 6 and 11 for 11b/g or channels 36, 40 and 64 for 11a.
Band – working bands on which your radios are working.
Six bands are supplied: 5GHz(11a), 5GHz(Turbo Mode 11a), 2.4GHz(Mixed 11g), 2.4GHz(11g
only), 2.4GHz(Mixed 11g WiFi) and 2.4GHz(11g only WiFi).
If 2.4GHz(Mixed 11g) or 2.4GHz(11g only) is selected, the radio will work on 2.4GHz for a better
performance. 2.4GHz (11g only) mode only allows 11g client access. 2.4GHz(Mixed 11g) mode
allows 11b/11g client access.
2.4GHz(Mixed 11g WiFi) or 2.4GHz(11g only WiFi) can make sure to compatible with Wi-Fi.
If 5GHz (11a) or 5GHz(Turbo Mode 11a) is selected, the radio will work on 5GHz 11A mode.
5GHz(Turbo Mode 11a) can supply 108 raw data rate.
Only under Bridge mode, Turbo Mode 11a can be set.