User's Manual
Table Of Contents
P-720 User’s Guide v1.0 Jun 10, 2005
Page 11 of 51
Connect to the Power Source and Local Network
There are two power supply methods can be used by P-720:
♦ Power-over-Ethernet equipment
♦ External Power Supply
Case 1 Use the Power-over-Ethernet Equipment:
Use the enclosed power cord or any IEEE802.3af Compliant POE Power Source
Devices to supply your P-720 Access Point.
Step 1 Place the Access Point on a flat work surface or hang on the wall.
Use the enclosed 4 screws to put the rear side of the Access Point hanging on the
wall.
Step 2 Connect the Ethernet cable from the P-720 route to an IEEE802.3-2003 compliant Power
source Equipment.
Step 3 If you use a POE HUB, please connect the P-720 LAN port to the PWR-LAN OUT port of
the POE HUB and connect the LAN-IN port of the POE HUB to the Switch or hub in the
local network.
Figure 5 – Connecting P-720 to Power source and network by PoE HUB
Case 2 Use External Power Supply
Item Connector Description
1 WLAN1 For WLAN1 RF card connecting to Antenna
2 WLAN2 For WLAN2 RF card connecting to Antenna
3 Power For power supply
4 Reset Reboot or reset to factory defaults.
Press the reset button for less than 5 seconds to reboot the
Access Point. Press the reset button for more than 5
seconds to set the Access Point to factory defaults.
5 LAN To your company LAN
6 Console For console connection