User Manual

User’s Guide Chapter 4 – Reference Manual
NTP Server – displays the NTP server.
Cancel – click the button to cancel changes.
Apply – click the button to save auto time and date settings.
To add the NTP host, click Add button under the NTP server’s table and a new pop-up window Add
NTP Server appears:
Figure 61 – Add a New NTP Server
NTP Server – specify the trusted NTP server host [1-128].
OK – saves added NTP host into configuration.
Cancel – close the window without saving information.
There is a possibility to add an additional NTP service host. The secondary NTP server will be used if
connection to the previously defined NTP server is lost.
Click the Delete button to delete desired NTP hosts and a new pop-up window Delete NTP Server
appears. You can select the hosts’ IP addresses that should be deleted as shown on the following
example:
Gemtek Systems Page 62