User Manual

User’s Guide Chapter 4 – Reference Manual
IP Address – enter the RADIUS server IP address [digit and dots].
UDP Port – specify the network port used to communicate with RADIUS [1-65535]. Default: 1812.
The port default value is 1812 in accordance with RFC 2865 " Remote
Authentication Dial-in User Service (RADIUS)".
Secret – specify the shared secret string that is used to encrypt data frames used for RADIUS servers
[4-64 symbols].
Confirm Secret – re-enter the RADIUS secret to verify its accuracy.
OK – saves added new RADIUS server into configuration.
Cancel – close the window without saving information.
Click the Delete button to delete desired RADIUS server, and new pop-up window Delete RADIUS
Servers appears. You can select the RADIUS server that should be deleted as shown on the
following example:
Figure 39 – Delete RADIUS server
OK – removes selected RADIUS servers from the system.
Cancel – close the window without saving information.
Configuration | Security | Wireless Security | Wired Equivalent Privacy (WEP)
WEP is a data privacy mechanism based on a 64-bit or 128-bit shared key algorithm as described in
the IEEE 802.11 standard. Static WEP uses a symmetric scheme where the same key and algorithm
are used for both encryption and decryption of data.
Use the Configuration | Security | Wireless Security| Wired Equivalent Privacy (WEP) menu to
configure the WEP encryption.
The checkbox Use WEP Encryption defines if encryption will be used or not. To enable WEP
encryption, select this checkbox:
Gemtek Systems Page 51