User Manual

User’s Guide Chapter 4 – Reference Manual
Figure 22 – Identity Settings
Name – specify the administrative name of the access point [string].
Location – specify the location where your device is installed [string].
Contact – specify the name of the person/company responsible for the P-520r [string].
MAC Address – displays the MAC address of the access point. Cannot be changed.
Access Point Type – displays information on your type of access point. Cannot be changed.
Firmware Version – displays the version number of the software that controls the access point.
Boot Loader Version – displays the boot loader version.
Cancel – restore all previous values.
Apply – save changed configuration.
Configuration | Local Area Network | Network Setup
The IP configuration as described below is required for device management purposes. IP addresses
can either be retrieved from a DHCP server or configured manually.
Figure 23 – Network Setup Settings
IP Address – specify the access point’s IP address [digit and dots]. When shipped from the factory or
reset to factory settings, the AP defaults to a static IP address of 192.168.2.2.
Gemtek Systems Page 37