User Manual

User’s Guide Chapter 2 – Installation
Removing the Access Point from the Wall
Step 1 Open the housing of the Access Point by pressing the spring latches on the upper
rear side of the access point using the disassembling tool delivered with your P-520r:
Figure 7 – Removing the P-520r Housing Using the Disassembling tool
Step 2 Release the housing from the wall-mounting clamp by carefully pressing the spring
latch in the center of the device (unit 5 in the
Figure 4 – Looking Inside the P-520r) using the point of the disassembling tool:
Figure 8 – Releasing the P-520r Housing
Step 3 Move the housing slightly upward and remove it.
Gemtek Systems Page 19