User Manual Part 3

WAN Quick Setup
4020210 Rev
A
107
c Select the VLAN Mux - Enable Multiple Protocols Over a Single PVC check
box, if applicable.
d In the VLAN ID[0-4095]: field, enter an ID for the VLAN. Values are: 0 to
4095.
e In the VPI field, enter the virtual path identifier (VPI). Values are: 0 to 65535.
f In the VCI field, enter the virtual channel identifier (VCI). Values are: 0 to
65535.
g In the Service Category field, select UBR Without PCR.
h Select the Enable Quality of Service check box, if applicable.
i Select the Obtain an IP address automatically option.
j Select the Obtain default gateway automatically option.
k Select the Obtain DNS server addresses automatically option.
l Select Enable NAT.
m Select the Enable IGMP Multicast check box.
n Select the Enable WAN Service check box.
7 Click Save. The system returns to the previous screen.
8 Click Reboot. This action reboots the residential gateway so that the WAN setup
configuration takes effect.